Hi Guys,
Although quite knowledgeable about commercial drones, quite a newbie regarding custom made racers and Open TX. I have a problem binding this configuration in the title. The info is scarce and the general idea is to put Taranis in bind mode, while holding the FC button and simultaneously plugging in the battery. In most cases successful binding should turn the red light into green. What I see is the still red light on one occassion or addiitonally blinking blue light on some occassions. In no case is the drone reacting to Tx commands. Drone responds fully in Betaflight configurator (motors and gyro). Any pointing in the right direction would be highly appreciated.
Kind Regards,
Mitja
Although quite knowledgeable about commercial drones, quite a newbie regarding custom made racers and Open TX. I have a problem binding this configuration in the title. The info is scarce and the general idea is to put Taranis in bind mode, while holding the FC button and simultaneously plugging in the battery. In most cases successful binding should turn the red light into green. What I see is the still red light on one occassion or addiitonally blinking blue light on some occassions. In no case is the drone reacting to Tx commands. Drone responds fully in Betaflight configurator (motors and gyro). Any pointing in the right direction would be highly appreciated.
Kind Regards,
Mitja