- Joined
- Dec 6, 2018
- Messages
- 6
- Reaction score
- 1
- Age
- 29
My 250 drone is updated and it has spracing f3 ...once battery is connected and if it’s turned on it does not responds to the transmitter...why this happens???its not arming....!
And make sure the battery is plugged in and you think you are ready to arm, then the status will tell you what is missing, but I would bet it is not seeing the RX, or throttle is not low enough.
If you've just updated your firmware, all your settings goes back to default if you didn't back them up before the flash, and restored them after the flash. You probably erased the arming mode which was set with the older firmware previously.