Hello all. I'm new but have done a bunch of research and self help before trying to post. I have a tinyhawk 3 RTF so it is paired with their new transporter goggles and the new e8 transmitter. The problem started when I hooked up to betaflight to recalibrate the accelerometer. You guess it, I hit restore to default. I tried to recalibrate because when I arm the drone it would spin up and stop almost immediately. (Drone has suffered no damage or hard crashes as of yet and is less than a week old). After that I started digging more. I had noticed when I connect transmitter and go to receiver tab the drone would spin on yaw axis rapidly. Mapping is correct and all other values move appropriately when input on toggles/gimbal. The yaw is reading that it is nearly fully pressed and when I counter direction in betaflight it does slow it down some, still only registers in the 1900 range when fully countered. I have reflashed/cli dump and restore, unbound and rebound controller, Tested motors, adjusting trim at controller (which helped a little but maxed out trim adjustment and still didn't correct) etc. I'm at a loss. I hope this is simple. I don't have another receiver to try and bind to see if that helps, but everything in betaflight seems right except when I connect my transmitter and the only thing that is out of whack is that it seems to be interpreting that I'm applying more than full right yaw when the stick is dead center. Sorry for any typos and please forgive me if I replaced transmitter with receiver ar vice versa in any instances. Any help would be appreciated! Edit I probably should've put this under transmitter and reciever but it doesn't appear that I can move it
Last edited: